Kawasaki Ninja Service Manual: Handlebar

Steering Stem Warp Inspection

Whenever the steering stem is removed, or if the steering can not be adjusted for smooth action, check the steering stem for straightness. If the steering stem [A] is bent, replace the steer ...

Handlebar Removal

Remove: Steering Damper (see Steering Damper Removal) Clutch Lever Clamp Bolts [A] Clutch Lever Assembly [B] Left Switch Housing [C] Handlebar Weight [D] Left Handlebar Grip [E] ...

Other materials:

Transmission Assy Assembly
Install the ball bearing [A] until it is bottomed. Turn the oil seal side to the bottom. Special Tool - Bearing Driver Set: 57001-1129 Install the bearing holder [B]. Turn the flat side to the bottom. Apply a non-permanent locking agent to the bearing holder bolts [C]. Tighten: ...

Stick Coil Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the ECU (see ECU Removal in the Fuel System (DFI) chapter). Do not disconnect the ECU connectors. Connect a digital meter [A] to the connector [B] with the needle adapter set. Special Tool - N ...

External Shift Mechanism Removal
Remove: Shift Lever (see Shift Pedal Removal) Oil Pump Drive Gear (see Oil Pump Drive Gear Removal/ Installation in the Engine Lubrication System chapter) Circlip [A] Washer [B] Special Tool - Outside Circlip Pliers: 57001-144 Remove: Shift Shaft Assembly [A] Washer [B] ...