Handlebar
Handlebar InstallationTroubleshooting guide
Engine Does Not Start
Starter Motor Won’t Turn
Engine stop switch off
Transmission not in neutral
Fuse blown
Battery leads do not make good electrical
contact with battery terminals
Battery discharged
Engine Cranks, But Won’t Start
No fuel in tank
Fuel line clogged
Fuel ...
Stick Coil Installation
Apply a thin coat of grease [A] to the stick coils for easy
installation.
Insert the stick coils so that the coil heads align with the
lines [B] on the cylinder head cover.
NOTICE
Do not tap the coil head while installing the coil.
After installation, be sure the stick coils are ...
Piston Wear Inspection
Measure the outside diameter [A] of each piston 5 mm
(0.20 in.) [B] up from the bottom of the piston at a right
angle to the direction of the piston pin.
If the measurement is under service limit, replace the piston.
Piston Diameter
Standard: 75.959 75.974 mm
(2.9905 2.9911 in.)
...