Kawasaki Ninja Owners Manual: Lap Counter/Coolant/Intake Air Temperature Meter

Kawasaki Ninja Owners Manual / General information / Meter instruments / Multifunction Meter / Lap Counter/Coolant/Intake Air Temperature Meter

This meter shows the coolant temperature, the intake air temperature or the lap number. The lap number is displayed in the stop watch mode, refer to the “Stop Watch” item in this section.

A. Lap Counter/Coolant / Intake Air Temperature Meter

The coolant temperature meter and intake air temperature meter modes can be shifted alternately by pushing the lower button.

NOTE

For safety reasons, do not operate the instrument buttons while riding the motorcycle.
The meter is displayed in the unit depending on the unit mode setting, refer to the “Unit Setting” item in this section.
The coolant temperature meter and intake air temperature meter cannot be shifted while displaying the stop watch or adjusting the clock.
When the battery is reconnected, the meter display is set to coolant temperature meter by default.

Stop Watch

The stop watch can be used in closed course competition. The stop watch is operated as follows: Push the upper button to display the stop watch. To start the stop watch, push the “STAR ...

Coolant Temperature Meter

The coolant temperature gauge indicates temperature of the engine coolant. The “ ” symbol is displayed if the coolant temperature meter is selected. A. Coolant Temperature Meter B. Warn ...

Other materials:

Average Mileage
This display mode shows the average mileage by numerical value counted from the start of measuring to present time. A. Average Mileage B. “AV km/L” While the average mileage is displayed, push the lower button and hold it in until the average mileage values resets to “– � ...

Air Intake Duct Assembly (Other than US, CA and CAL Models)
Install the seals [A] as shown in the figure. Fit the projections [A] of the air intake valve to the hole [B] of the air intake ducts. Tighten: Torque - Air Intake Duct Assembly Screws: 1.5 N·m (0.15 kgf·m, 13 in·lb) Hang the shaft [A] to the air intake valve securely ...

DFI Parts Location
Main Throttle Sensor [A] Subthrottle Sensor [B] Idle Speed Control Valve Actuator [C] Subthrottle Valve Actuator [D] Intake Air Pressure Sensor #2 [E] Stick Coils #1, #2, #3, #4 [F] Air Switching Valve [G] Intake Air Pressure Sensor #1 [H] Water Temperature Sensor [A] Primary Fuel Injec ...