Remove the radiator cap in two steps. First turn the cap counterclockwise to the first stop. Then push and turn it further in the same direction and remove the cap.
NOTE
Wet the cap sealing surfaces with water or coolant to prevent pressure leaks.
NOTICE
During pressure testing, do not exceed the pressure for which the system is designed. The maximum pressure is 142 kPa (1.45 kgf/cm², 21 psi).
If the pressure holds steady, the system is all right.
If the pressure drops and no external source is found, check for internal leaks. Droplets in the engine oil indicate internal leakage. Check the cylinder head gasket and the water pump.
Remove the pressure tester, replenish the coolant, and install the radiator cap.
Meter instruments
Upper Button
Lower Button
Tachometer (with Shift-Up
Indicator)
Red Zone
Ambient Brightness
Sensor
Turn Signal Indicator Light
Warning Indicator Light
(Red)
Neutral Indicator Light
Multifunction Meter
High Beam Indicator Light
Warning Indicator Light
(Yellow)
Fuel ...
Rear Frame Front Removal
Remove:
Rear Frame Rear (see Rear Frame Rear Removal)
Rear Fender Front (see Rear Fender Front Removal)
Rear Footpeg Bracket Bolts [A]
Rear Footpeg Bracket [B]
Rear Frame Front Bolts [C]
Left Rear Frame Front [D]
Remove:
Rear Footpeg Bracket Bolts [A]
Rear Footpeg Bracke ...
Crankshaft Sensor Inspection
Disconnect the crankshaft sensor lead connector (see
Crankshaft Sensor Removal).
Set the hand tester [A] to the × 10 Ω range and connect it
to the crankshaft sensor lead connector [B].
Special Tool - Hand Tester: 57001-1394
Crankshaft Sensor Resistance
Connections:
Meter (+ ...