Kawasaki Ninja Service Manual: Cooling System

Kawasaki Ninja Service Manual / Cooling System

Canister Inspection
Refer to the Evaporative Emission Control System Inspection (CAL and SEA-B1 Models) in the Periodic Maintenance chapter. 1. Green Hoses (Purge) 2. Fittings 3. Canister 4. White Hose ( ...

Exploded View
14. Thermostat 15. Frame No. JKAZXT00JJA003074 or JKAZXCJ1 BA003074 G: Apply grease. HG: Apply high-temperature grease. L: Apply a non-permanent locking agent. R: Replacement Parts ...

Other materials:

Rear Wheel Removal
Raise the rear wheel off the ground with the stand [A]. Remove: Cotter Pin [A] Rear Axle Nut [B] Washer [C] Rear Axle [D] (from Right Side) Remove the rear wheel rotation sensor from the caliper bracket (see Rear Wheel Rotation Sensor Removal in the Brakes chapter). ...

Intake Air Pressure Sensor #1 Output Voltage Inspection
Measure the output voltage at the intake air pressure sensor #1 in the same way as input voltage inspection, note the following. Disconnect the intake air pressure sensor #1 connector and connect the measuring adapter [A] between these connectors. [B] Main Harness [C] Intake Air Pressu ...

Shift Fork Guide Pin/Drum Groove Wear Inspection
Measure the diameter of each shift fork guide pin [A], and measure the width [B] of each shift drum groove. If the guide pin on any shift fork is less than the service limit, the fork must be replaced. Shift Fork Guide Pin Diameter Standard: 6.9 7.0 mm (0.272 0.276 in.) Service Limit: ...