Insert the needle bearing driver [A] into the needle bearing [B] and press the needle bearing into the housing until the driver contacts the end surface of the housing.
NOTE
Special Tools - Bearing Driver Set: 57001-1129
Needle Bearing Driver, 28:
57001-1610
Spacer 28: 57001-1663
Needle Bearing Driver, 20 &
Spacer, 28
(Spacer): 57001-1678
Press in the ball bearing until it bottomed.
Special Tool - Bearing Driver Set: 57001-1129
Special Tool - Inside Circlip Pliers: 57001-143
Special Tool - Bearing Driver Set: 57001-1129
32 mm (1.26 in.) [A] 1 mm (0.04 in.) [B] 1.5 mm (0.06 in.) [C] 9.5 mm (0.37 in.) [D] 27.5 mm (1.08 in.) [E] Needle Bearings [F] Grease Seals [G] Ball Bearing [H] Circlip [I]
Rider’s Seat Removal
Remove the bolts and seat cover.
A. Bolts
B. Seat Cover
Remove the mounting bolts and pull
off the seat upward.
A. Mounting Bolts
B. Rider’s Seat ...
Related Parts Locations
KIBS Control
1. ABS performance equivalent to the current model (enhanced braking
stability)
By monitoring front caliper hydraulic pressure, KIBS regulates pressure
increases reducing the tendency
of the rear to lift. Before the ABS system fully reacts, KIBS system prevents
the pressure ...
Master Cylinder Inspection (Visual Inspection)
Remove the master cylinders (see Front/Rear Master
Cylinder Removal).
Disassemble the front and rear master cylinders (see
Master Cylinder Rubber Parts Replacement in the Periodic
Maintenance chapter).
Check that there are no scratches, rust or pitting on the
inner wall [A] of each ma ...