Kawasaki Ninja Service Manual: Torque Limiter

Kawasaki Ninja Service Manual / Crankshaft/Transmission / Torque Limiter

Balancer Damper Inspection
Remove the balancer and disassemble the weight and gear assembly. Visually inspect the rubber dampers [A]. If they appear damaged or deteriorated, replace them. ...

Torque Limiter Removal
Remove: Starter Motor (see Starter Motor Removal in the Electrical System chapter) Throttle Body Assy Holder [A] Breather Hose [B] Roll up the heat insulation rubber plate [C]. ...

Other materials:

Engine Sprocket Installation
Replace the sprocket washer and axle cotter pin. Install the engine sprocket onto the output shaft. Apply molybdenum disulfide oil solution to the threads and seating surface of the engine sprocket nut. Tighten: Torque - Engine Sprocket Nut: 145 N·m (14.8 kgf·m, 107 ft·lb) NOTE ...

Exhaust Butterfly Valve Actuator Resistance Inspection
Turn the ignition switch to OFF. Disconnect the exhaust butterfly valve actuator lead connector (2 pins connector) [A]. Set the hand tester to the × 1 Ω range and connect it to the exhaust butterfly valve actuator connector. Special Tool - Hand Tester: 57001-1394 Measure ...

Subthrottle Valve Actuator Inspection
NOTE Be sure the battery is fully charged. Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter). Turn the ignition switch to ON. Check to see that all the subthrottle valves [A] open and close smoothly. Turn the ignition switch to OFF. I ...