Turn the oil seal side to the bottom.
Special Tool - Bearing Driver Set: 57001-1129
Turn the flat side to the bottom.
Turn the stepped edge to upside.
Special Tool - Bearing Driver Set: 57001-1129
Turn the flat side to the bottom.
Tighten: Torque - Transmission Case Bearing Holder Bolts: 4.9 N·m (0.50 kgf·m, 43 in·lb)
Turn the flat side to the bottom.
Spring [A] Washer [B] Gear Positioning Lever [C]
The shift fork [D] for drive shaft has “A2” mark. Turn the mark to the upside.
The shift forks [E] for output shaft have “A1” mark. Turn the mark to the bottom.
The shift forks [F] for output shaft have “A3” mark. Turn the mark to the bottom.
Piston Ring Thickness Inspection
Measure the piston ring thickness.
Use the micrometer to measure at several points around
the ring.
Piston Ring Thickness
Standard:
Top [A] 0.77 0.79 mm (0.0303
0.0311 in.)
Second [B] 0.78 0.79 mm
(0.0307 0.0311 in.)
Service Limit:
Top 0.70 mm (0.0276 in.)
Second 0.71 mm (0.0280 ...
Tire Installation
WARNINGSome replacement tires may adversely
affect handling
and cause an accident resulting in serious injury
or death. To ensure proper handling and stability,
use only the recommended standard tires for
replacement, inflated to the standard pressure.
Inspect the rim ...
Refreshing Charge
Remove the battery (see Battery Removal).
Do refresh charge by following method according to the
battery terminal voltage.
WARNINGThis battery is sealed type. Charge with
current and
time as stated below.
Terminal Voltage: 12.0 12.7
V
Standard Charge (see following ...