Kawasaki Ninja Service Manual: Transmission Assy Disassembly

Transmission Assy Removal

Remove: Engine Sprocket (see Engine Sprocket Removal in the Final Drive chapter) Gear Position Switch (see Gear Position Switch Removal in the Electrical System chapter) Collar [A] O-ri ...

Transmission Assy Assembly

Install the ball bearing [A] until it is bottomed. Turn the oil seal side to the bottom. Special Tool - Bearing Driver Set: 57001-1129 Install the bearing holder [B]. Turn the flat side ...

Other materials:

Cleaning Vehicle before Disassembly
Clean the vehicle thoroughly before disassembly. Dirt or other foreign materials entering into sealed areas during vehicle disassembly can cause excessive wear and decrease performance of the vehicle. Arrangement and Cleaning of Removed Parts Disassembled parts are easy to confuse. Arrange ...

Oil Level Inspection
Check that the engine oil level is between the upper [A] and lower [B] levels in the gauge. NOTE Situate the motorcycle so that it is perpendicular to the ground. If the motorcycle has just been used, wait several minutes for all the oil to drain down. If the oil has just been changed, ...

Shifting Gears
Close the throttle while pulling in the clutch lever. Shift into the next higher or lower gear. Open the throttle part way, while releasing the clutch lever. For smooth riding, each gear position should cover the proper rate of speed shown in the table. WARNINGDownshifti ...