WARNING This battery is sealed type. Charge with current and time as stated below. |
Terminal Voltage: 12.0 12.7
V
Standard Charge (see following chart):
ZX1000J: 0.6 A × 5 10 h
ZX1000K: 0.9 A × 5 10 h
Quick Charge
ZX1000J: 3 A × 5 1 h
ZX1000K: 4.5 A × 1 h
NOTICE
If possible, do not quick charge. If quick charge is done unavoidably, do standard charge later on.
Terminal Voltage: 12 V or lower Charging Method: 0.6 A × 20 h
Kawasaki-recommended chargers: Battery Mate 150-9
OptiMate PRO 4-S/PRO S/PRO 2
Yuasa MB-2040/2060
Christie C10122S
NOTE
Increase the charging voltage to a maximum voltage of 25 V if the battery will not accept current initially. Charge for nomore than 5minutes at the increased voltage then check if the battery is drawing current. If the battery will accept current decrease the voltage and charge by the standard charging method described on the battery case. If the battery will not accept current after 5 minutes, replace the battery.
Battery [A] Battery Charger [B] Standard Value [C] Current starts to flow [D].
Determine the battery condition left for 30 minutes after completion of the charge by measuring the terminal voltage according to the table below.
Camshaft Chain Tensioner Installation
Replace the O-ring [A] with a new one.
Apply grease to the new O-ring.
Release the stopper [B] and push the push rod [C] into the
interior of the tensioner body [D] so that the position of the
push rod is 3 or 4 notches [E] as shown in the figure.
Install the tensioner body so that the ...
Rear Master Cylinder Installation
Replace the washers that are on each side of hose fitting
with new ones.
Install the brake hose [A].
Touch the brake hose to the stopper [B] of the rear master
cylinder.
Tighten:
Torque - Brake Hose Banjo Bolt: 25 N·m (2.5 kgf·m, 18 ft·lb)
Install the master cylinder, the brack ...
Transmission Shaft Disassembly
Remove the transmission shafts (see Transmission Shaft
Removal).
Remove the circlips, and then disassemble the transmission
shafts.
Special Tool - Outside Circlip Pliers: 57001-144
The 5th gear [A] on the output shaft has three steel balls
assembled into it for the positive neutral fin ...