Kawasaki Ninja Service Manual: Upper Fairing Assembly Removal

Kawasaki Ninja Service Manual / Frame / Fairings / Upper Fairing Assembly Removal

Remove: Lower Fairings (see Lower Fairing Removal) Center Inner Fairing (see Center Inner Fairing Removal) Upper Inner Fairings (see Upper Inner Fairing Removal) Windshield (see Windshield Removal)
Disconnect the front turn signal light lead connector [A] (both sides).
Remove the bolts [B] and the rear view mirror [C] (both sides).

Upper Fairing Assembly Removal

Disconnect: Regulator/Rectifier Connectors [A] Headlight Lead Connector [B]
Remove the fuse box [C].
Open the clamp [D].

Upper Fairing Assembly Removal

Disconnect: City Light Lead Connector [A] Headlight Lead Connector [B]
Open the clamps [C].

Upper Fairing Assembly Removal

For models equipped with an evaporative emission control system, note the following.

Take the hoses [A] off the canister [B].

Open the clamp [C].

Remove the quick rivet [D].

Upper Fairing Assembly Removal

Remove the bolts [A], and take off the upper fairing assembly.

Upper Fairing Assembly Removal

Lower Fairing Installation

Installation is the reverse of removal. Note the following. When installing the pad [A], align the edge of the pad and the marking of the fairing [B]. When installing the pad [C], align the ed ...

Upper Fairing Assembly Installation

Installation is the reverse of removal. Note the following. Run the hoses, leads and harness correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter). Spread the upper fai ...

Other materials:

Unit Setting
The unit setting in the meter instrument can be changed according to local regulations. Make sure the unit setting is correctly displayed before riding. A. Speedometer B. Meter Display Units NOTE Do not operate the motorcycle with wrong unit (mph or km/h) of the speedometer. To change ...

Transmission Assy Installation
Assemble the transmission assy (see Transmission Assy Assembly). Be sure that the dowel pins are in position. Install the transmission assy on the crankcase. Tighten: Torque - Transmission Case Bolts: 20 N·m (2.0 kgf·m, 15 ft·lb) Install: Shift Shaft (see External Shift Mechani ...

Exhaust Pipe Installation
Replace the exhaust pipe gaskets [A] and premuffler chamber gasket [B] with new ones. Install the premuffler chamber gasket to the premuffler chamber [C] until it is bottomed so that the chamfer side faces exhaust pipe [D]. Install the exhaust pipe clamp [E] as shown in the figure. I ...