Kawasaki Ninja Service Manual: ESD (Electronic Steering Damper) ECU Installation (ZX1000JD/KD)

Kawasaki Ninja Service Manual / Steering / Steering Damper / ESD (Electronic Steering Damper) ECU Installation (ZX1000JD/KD)

ESD (Electronic Steering Damper) ECU Installation (ZX1000JD/KD)


ESD (Electronic Steering Damper) ECU Removal (ZX1000JD/KD)
NOTICE Never drop the ECU especially on a hard surface. Such a shock to the ECU can damage it. Lift up the front portion of the fuel tank, and hold it with a suitable bar or block (see Fuel ...

Steering Stem
...

Other materials:

Valve Guide Removal
Remove: Valve (see Valve Removal) Oil Seal Spring Seat Heat the area around the valve guide to 120 150°C (248 302°F), and hammer lightly on the valve guide arbor [A] to remove the guide from the top of the head. NOTICE Do not heat the cylinder head with a torch. This ...

Subthrottle Sensor Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Disconnect the subthrottle sensor connector and connect the harness adapter [A] between these connectors. Spec ...

Tie-Rod and Rocker Arm Bearing Installation
Replace the needle bearings [A] and oil seals with new ones. Apply plenty of grease to the lips of the oil seals. Install the needle bearings and oil seals position as shown in the figure. Screw the needle bearing driver into the driver holder. Insert the needle bearing driver into th ...