Kawasaki Ninja Owners Manual: Seats

Kawasaki Ninja Owners Manual / General information / Seats

Side Stand
The motorcycle is equipped with a side stand. A. Side Stand NOTE When using the side stand, turn the handlebar to the left. Do not sit on the motorcycle while it is on its side stand or cen ...

Passenger’s Seat Removal
Remove the passenger’s seat by inserting the ignition key into the seat lock, and turning it clockwise. A. Seat Lock B. Ignition Key C. Passenger’s seat D. Pull up NOTE When rem ...

Other materials:

Rear Wheel Rotation Sensor Signal Abnormal (Service Code b 44)
Measure the air gap between the rear wheel rotation sensor and sensor rotor. Thickness Gauge [A] Air Gap Standard: 0.4 1.6 mm (0.02 0.06 in.) If the measurement is not the standard, check each part for deformation and looseness and correct accordingly. If the measurement is the sta ...

Rear Sprocket Warp Inspection
Raise the rear wheel off the ground with the stand so that it will turn freely. Set a dial gauge [A] against the rear sprocket [B] near the teeth as shown in the figure, and rotate [C] the rear wheel to measure the sprocket runout (warp). The difference between the highest and lowest di ...

Shift Drum Assembly
Press and insert the ball bearing [A] on the shift drum [B] until it is bottomed. Install: Ball Bearing [C] Dowel Pin [D] and Shift Drum Cam [E] Align the pin with the groove in the shift drum cam. Apply a non-permanent locking agent to the shift drum cam holder bolt [F]. Tight ...