Kawasaki Ninja Service Manual: Immobilizer Amplifier (Service Code 35, Equipped Models)

Kawasaki Ninja Service Manual / Self-Diagnosis System / Immobilizer Amplifier (Service Code 35, Equipped Models)

Exhaust Butterfly Valve Actuator Sensor Resistance Inspection
Turn the ignition switch to OFF. Disconnect the exhaust butterfly valve actuator sensor connector (3 pins connector) [A] (see Exhaust Butterfly Valve Actuator Sensor Input Voltage Inspection) ...

Antenna Resistance Inspection
Turn the ignition switch to OFF. Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter). Disconnect the antenna lead connector [A]. Measure the an ...

Other materials:

Air Suction Valve Inspection
Remove the air suction valve (see Air Suction Valve Removal). Visually inspect the reeds [A] for cracks, folds, warps, heat damage or other damage. If there is any doubt as to the condition of the reeds, replace the air suction valve as an assembly. Check the reed contact areas [B] of ...

Safe riding technique
The points given below are applicable for everyday motorcycle use and should be carefully observed for safe and effective vehicle operation. For safety, eye protection and a helmet are strongly recommended. You should be aware of and verify the applicable safety regulations in force prior ...

Handlebar Installation
Apply a non-permanent locking agent to the threads of the handlebar positioning bolts and tighten them. Torque - Handlebar Positioning Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb) Install the steering stem head with handlebars. Install the washer [A] and steering stem head nut [B]. Tighten: ...