Kawasaki Ninja Service Manual: Oil Cooler Removal

Oil Cooler

...

Oil Cooler Installation

Replace the O-ring [A] with a new one. Apply grease to the new O-ring. Install the water hoses and hose clamps [A] as shown in the figure. Water Hose (About 300 mm, 11.8 in.) [B] ...

Other materials:

Warning Indicator Light (LED)
Light (LED) Inspection The warning indicator light (LED) [A] is used for the FI indicator, immobilizer indicator (immobilizer equipped models), water temperature warning indicator and oil pressure warning indicator. In this model, the warning indicator light (LED) (FI/immobilizer) goes ...

Intake Air Pressure Sensor #2 Output Voltage Inspection
Measure the output voltage at the intake air pressure sensor #2 in the same way as input voltage inspection, note the following. Disconnect the intake air pressure sensor #2 connector and connect the measuring adapter [A] between these connectors. [B] Main Harness [C] Intake Air Pressu ...

Troubleshooting guide
Engine Does Not Start Starter Motor Won’t Turn Engine stop switch off Transmission not in neutral Fuse blown Battery leads do not make good electrical contact with battery terminals Battery discharged Engine Cranks, But Won’t Start No fuel in tank Fuel line clogged Fuel ...