Kawasaki Ninja Service Manual: Engine Lubrication System

Damper Cam Inspection

Remove the clutch (see Clutch Removal). Visually inspect the damper cam[A], cam follower [B], and the torque limiter spring [C]. Replace the part if it appears damaged. ...

Exploded View

EO: Apply engine oil. G: Apply grease. L: Apply a non-permanent locking agent. Lh: Left-hand Threads MO: Apply molybdenum disulfide oil solution. (mixture of the engine oil and mo ...

Other materials:

Shift Fork Guide Pin/Drum Groove Wear Inspection
Measure the diameter of each shift fork guide pin [A], and measure the width [B] of each shift drum groove. If the guide pin on any shift fork is less than the service limit, the fork must be replaced. Shift Fork Guide Pin Diameter Standard: 6.9 7.0 mm (0.272 0.276 in.) Service Limit: ...

Rear Wheel Rotation Sensor Wiring Inspection (Service Code b 45)
Disconnect the rear wheel rotation sensor lead connector [A] (see Rear Wheel Rotation Sensor Removal in the Brakes chapter). Disconnect the KIBS hydraulic unit lead connector (see KIBS Hydraulic Unit Removal in the Brakes chapter). Check the wiring continuity of the G lead and R ...

Spark Plugs
The standard spark plug is shown in the table. The spark plugs should be replaced in accordance with the Periodic Maintenance Chart. Spark plug removal should be done only by a competent mechanic following the instructions in the Service Manual. Spark Plug A. Plug Gap ...