The Output Fluid Pressure Sensor is built in the KIBS Hydraulic Unit. Therefore the sensor cannot be checked directly.
If this service code appears even if all checks are ended, replace the KIBS hydraulic unit.
If the service code does not appear, the KIBS system normal (temporary failure).
Output Fluid Pressure Sensor (Front Brake) Wiring Inspection (Service Code b
83)
Fluid Pressure Sensor Supply Voltage Inspection (Service Code b 89)CAN Communication Line
CAN Communication Line
Resistance Inspection
In this model, resistors for CAN communication line are
built in the ECU [A] and meter unit.
Refer to the Meter Unit Inspection in the Electrical System
chapter for the resistor in the meter unit.
Turn the ignition switch to OFF.
Remove:
EC ...
Check 2-2: Fuel Level Warning Inspection
Remove:
Fuel Tank (see Fuel Tank Removal in the Fuel System
(DFI) chapter)
Connect the resistor(s) [A] (about 50 to 100 Ω) between
the fuel pump connector terminal [B] of the main harness
side and the battery negative (–) terminal [C] as shown.
Turn the ignition switch ...
Fuel Tank Installation
Note the above WARNING (see Fuel Tank Removal).
Run the hoses correctly (see Cable, Wire, and Hose Routing
section in the Appendix chapter).
Check that the dampers [A] are in place on the fuel tank.
If the dampers are damaged or deteriorated, replace
them.
If the fuel tank brack ...