The oxygen sensor heater is built in the oxygen sensor.
So, the heater itself can not be removed. Remove the oxygen sensor (see Oxygen Sensor Removal (Equipped Models) in the Electrical System chapter).
Oxygen Sensor Heater Resistance InspectionCheck 3-4: Turn Signal Indicator Light (LED) Inspection
Connect the leads in the same circuit as Check 3-2.
Connect the terminal [5] to the battery (+) terminal.
Connect the terminal [6] to the battery (+) terminal.
Check that the turn signal indicator light (LED) [A] goes
on.
If the indicator light does not go on, replace the meter ...
Evaporative Emission Control System (California
model only)
This system routes fuel vapors from
the fuel system into the running engine
or stores the vapors in a canister when
the engine is stopped. Although no adjustments
are required, a thorough visual
inspection must be made at the intervals
specified by the Periodic Maintenance
Chart.
Inspection
...
Troubleshooting Guide
NOTE
Refer to the Fuel System chapter for most
of DFI trouble shooting guide.
This is not an exhaustive list, giving every
possible cause for each problem listed. It
is meant simply as a rough guide to assist
the troubleshooting for some of the more
common difficulties.
Engine Doe ...
