Kawasaki Ninja Owners Manual: Parking

Kawasaki Ninja Owners Manual / How to ride the motorcycle / Parking

WARNING

Operating or parking the vehicle near flammable materials can cause a fire, and can result in property damage or severe personal injury.

Do not idle or park your vehicle in an area where tall or dry vegetation, or other flammable materials could come into contact with the muffler or exhaust pipe.

The engine and exhaust system get extremely hot during normal operation and can cause serious burns.

Never touch a hot engine, exhaust pipe, or muffler during operation or after stopping the engine.

Shift the transmission into neutral and turn the ignition key to “OFF”.
Support the motorcycle on a firm, level surface with the side stand.

NOTICE

Do not park on a soft or steeply inclined surface, or the motorcycle may fall over.

If parking inside a garage or other structure, be sure it is well ventilated and the motorcycle is not close to any source of flame or sparks; this includes any appliance with a pilot light.

WARNING

Gasoline is extremely flammable and can be explosive under certain conditions.

Lock the steering to prevent theft.

Stopping the Motorcycle in an Emergency

Your Kawasaki Motorcycle has been designed and manufactured to provide you optimum safety and convenience. However, in order to fully benefit from Kawasaki’s safety engineering and craftsmans ...

Catalytic Converter

This motorcycle is equipped with a catalytic converter in the exhaust system. The converter reacts with carbonmonoxide, hydrocarbons and nitrogen oxides to convert them into carbon dioxide, wat ...

Other materials:

Oil Pressure Measurement
Remove: Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Oil Passage Plug [A] Attach the adapter [A] and gauge [B] to the plug hole. Special Tools - Oil Pressure Gauge, 10 kgf/cm²: 57001-164 Oil Pressure Gauge Adapter, PT3/8: 57001 -1233 ...

Cam Wear Inspection
Remove the camshafts (see Camshaft Removal). Measure the height [A] of each cam with a micrometer. If the cams are worn down past the service limit, replace the camshaft. Cam Height Standard: Exhaust 35.043 35.157 mm (1.3796 1.3841 in.) Intake 38.243 38.357 mm (1.5056 1.5101 in. ...

Spring Plate Free Play Measurement
Insufficient clutch free play will cause the engine braking effect to be more sudden, resulting in rear wheel hop. On the other hand, if the free play is excessive, the clutch lever may feel “spongy” or pulsate when pulled. Hold an extra drive shaft in a vise and install the following c ...