Kawasaki Ninja Owners Manual: Starter Button

Kawasaki Ninja Owners Manual / General information / Right Handlebar Switches / Starter Button

The starter button operates the electric starter when the transmission is in neutral.

Refer to the Starting the Engine section of the “How to Ride the Motorcycle” chapter for starting instructions.

START/STOP Switch (for Stop Watch)

Refer to the Multifunction Meter section of this chapter for stop watch instructions.

Engine Stop Switch

A. Engine Stop Switch B. START/STOP Switch (for Stop Watch) C. Starter Button In addition to the ignition switch, the engine stop switch must be in the position for the motorcycle to operat ...

Brake Lever Adjuster

There is an adjuster on the brake lever. The adjuster has 6 positions so that the released lever position can be adjusted to suit the operator’s hands. Push the lever forward and turn the adju ...

Other materials:

Wheel Inspection
Raise the front/rear wheel off the ground. Special Tools - Jack: 57001-1238 Jack Attachment: 57001-1608 Spin the wheel lightly, and check for roughness or binding. If roughness or binding is found, replace the hub bearings (see Hub Bearing Removal/Installation). Inspect the wh ...

Rear Brake Pad Installation
Check that the pad spring is in place on the caliper. Push the caliper piston in as far as it will go. Install the piston side pad [A] first, and then another pad. Fit the brake pad end into the recess [B] of the caliper holder. Install the pad pin and the plug. Tighten: Torque - ...

Brake Hose and Pipe Damage and Installation Condition Inspection
Inspect the brake hoses, pipes and fittings for deterioration, cracks and signs of leakage. The high pressure inside the brake line can cause fluid to leak [A] or the hose to burst if the line is not properly maintained. Bend and twist the rubber hose while examining it. Replace the ...