If there is any doubt as to the condition of the reeds, replace the air suction valve as an assembly.
If there is any doubt as to the condition of the reed contact areas, replace the air suction valve as an assembly.
If any carbon or other foreign particles have accumulated between the reed and the reed contact area, wash the valve assembly clean with a high flash-point solvent.
NOTICE
Do not scrape off the deposits with a scraper as this could damage the rubber, requiring replacement of the suction valve assembly.
Idle Speed Control Valve Actuator Input Voltage Inspection
NOTE
Be sure the battery is fully charged.
Turn the ignition switch to OFF.
Disconnect the idle speed control valve actuator connector
and connect a suitable measuring leads [A] between
these connectors as shown in the figure.
Main Harness [B]
Idle Speed Control Valve Actua ...
Nozzle Assy Disassembly
Remove the nozzle assy (see Nozzle Assy Removal).
Pull out the secondary fuel injectors [A] from the delivery
pipe assy [B].
NOTE
Do not damage the insertion portions of the injectors
when they are pulled out from the delivery pipe assy.
NOTICE
Never drop the secondary fuel injecto ...
Warning Symbols
: The red
warning indicator light
and the oil pressure warning symbol
( )
goes on whenever the oil pressure
is dangerously low or the ignition switch is in the “ON” position with the
engine not running, and go off when the
engine oil pressure is high enough. Refer
to the Mainten ...