Kawasaki Ninja Service Manual: Nozzle Assy Disassembly

Kawasaki Ninja Service Manual / Fuel System (DFI) / Nozzle Assy / Nozzle Assy Disassembly

NOTE

Do not damage the insertion portions of the injectors when they are pulled out from the delivery pipe assy.

Nozzle Assy Disassembly


NOTICE

Never drop the secondary fuel injector especially on a hard surface. Such a shock to the injector can damage it.

NOTE

Mark and record the location of the delivery pipes and the joint pipe so that the delivery pipe assy can be reassembled in the original position.

Nozzle Assy Installation
Replace the dust seals [A] with new ones. Apply engine oil to the new dust seals, and install them. Install the nozzle assy securely. Push the four mounting positions of the injectors. Set ...

Nozzle Assy Assembly
Before assembling, blow away dirt or dust from the delivery pipes [A] by applying compressed air [B]. Replace the O-rings [A] of the joint pipe [B] with new ones. Apply engine oil to ...

Other materials:

Lubrication
It is important to lubricate rotating or sliding parts during assembly to minimize wear during initial operation. Lubrication points are called out throughout this manual, apply the specific oil or grease as specified. Direction of Engine Rotation When rotating the crankshaft by hand, the fre ...

Chassis Parts Lubrication
Before lubricating each part, clean off any rusty spots with rust remover and wipe off any grease, oil, dirt, or grime. Lubricate the points listed below with indicated lubricant. NOTE Whenever the vehicle has been operated under wet or rainy conditions, or especially after using a high ...

Reporting safety defects
(For Products Sold in the United States of America, District of Columbia, and U.S. Territories Only) If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHT ...