Brake Hose Removal/Installation
Brake Hose Inspection
Clutch Cover Installation
Using a cleaning fluid, clean off any oil or dirt that may
be on the silicone sealant coating area. Dry them with a
clean cloth.
Apply silicone sealant to the area [A] where the mating
surface of the crankcase touches the clutch cover gasket.
Sealant - Liquid Gasket, TB1211F: 92104-000 ...
Charging Voltage Inspection
Check the battery condition (see Charging Condition Inspection).
Warm up the engine to obtain actual alternator operating
conditions.
Remove the front seat (see Front Seat Removal in the
Frame chapter).
Check that the ignition switch is turned off, and connect
the hand tester [A] to t ...
Oil Level Inspection
Check that the engine oil level is between the upper [A]
and lower [B] levels in the gauge.
NOTE
Situate the motorcycle so that it is perpendicular to the
ground.
If the motorcycle has just been used, wait several minutes
for all the oil to drain down.
If the oil has just been changed, ...