Kawasaki Ninja Service Manual: Connecting Rod Bend Inspection

Kawasaki Ninja Service Manual / Crankshaft/Transmission / Crankshaft and Connecting Rods / Connecting Rod Bend Inspection

Remove the connecting rod big end bearing inserts, and reinstall the connecting rod big end cap.
Select an arbor [A] of the same diameter as the connecting rod big end, and insert the arbor through the connecting rod big end.
Select an arbor of the same diameter as the piston pin and at least 100 mm (3.94 in.) long, and insert the arbor [B] through the connecting rod small end.
On a surface plate, set the big-end arbor on V block [C].
With the connecting rod held vertically, use a height gauge to measure the difference in the height of the arbor above the surface plate over a 100 mm (3.94 in.) length to determine the amount of connecting rod bend.

If the connecting rod bend exceeds the service limit, the connecting rod must be replaced.

Connecting Rod Bend Service Limit: TIR 0.2/100 mm (0.008/3.94 in.)

Connecting Rod Bend Inspection

Crankshaft/Connecting Rod Cleaning

After removing the connecting rods from the crankshaft, clean them with a high flash-point solvent. Blow the crankshaft oil passages with compressed air to remove any foreign particles or res ...

Connecting Rod Twist Inspection

With the big-end arbor [A] still on V block [C], hold the connecting rod horizontally and measure the amount that the arbor [B] varies from being paralleled with the surface plate over a 100 ...

Other materials:

Storage
Preparation for Storage Clean the entire vehicle thoroughly Run the engine for about five minutes to warm the oil, shut it off, and drain the engine oil. WARNINGEngine oil is a toxic substance. Dispose of used oil properly. Contact your local authorities for approved disp ...

S-KTRC Mode Indicator
This indicator shows the selected S-KTRC mode. For more detailed information about the S-KTRC mode, see Sport-Kawasaki TRaction Control (S-KTRC) section in the How to Ride the Motorcycle chapter A. S-KTRC Mode Indicator NOTE When the all S-KTRC mode indicators go off, the battery voltag ...

General Lubrication
Lubricate the points shown below, with either motor oil or regular grease, in accordance with the Periodic Maintenance Chart or whenever the vehicle has been operated under wet or rainy conditions. Before lubricating each part, clean off any rusty spots with rust remover and wipe off any g ...