NOTICE
The O-rings between the side plates seal in the lubricant between the pin and the bushing. To avoid damaging the O-rings and resultant loss of lubricant, observe the following rules.
Use only kerosene or diesel oil for cleaning of the O-ring of the drive chain. Any other cleaning solution such as gasoline will cause deterioration and swelling of the O-ring. Immediately blow the chain dry with compressed air after cleaning. Complete cleaning and drying the chain within 10 minutes.
Oil Applied Areas [A] O-rings [B]
Headlight Aiming Adjustment
NOTE
Do not turn the bolts [A] because the reflector in the
headlight comes off.
(In the photo, the headlight unit has been removed for
clarity.)
NOTE
The left adjuster [A] and right adjuster [B] can move the
direction of the headlight beam to up, down, left and
right by turning each a ...
Turn Signal Switch
When the turn signal switch is
pushed to the left ( ) or right
( ), the corresponding turn signals
blink on and off.
To stop blinking, push the switch in.
Horn Button
When the horn button is pushed, the
horn sounds
LAP/Passing Button
When the LAP/passing button is
pushed, the headlight hi ...
Fuse Box Fuse Removal
Remove the left upper inner fairing (see Upper Inner Fairing
Removal in the Frame chapter).
Unlock the hook [A] to take off the fuse box 1 [B].
Unlock the hook [C] to lift up the lid.
Pull the fuses [A] straight out of the fuse box 1 with needle
nose pliers.
Fuse Box 2
...