This ECU is built in the KIBS Hydraulic Unit. Therefore the ECU cannot be checked directly.
If this service code appears even if all checks are ended, replace the KIBS hydraulic unit.
If the service code does not appear, the KIBS system normal (temporary failure).
Power Supply Voltage Inspection (Over-Voltage) (Service Code b 53)
CAN Communication (Transmission)/CAN Bus OFF Monitor Inspection (Service Code
b 57) CAN Communication (Reception) Monitor Inspection (Service Code b 58)Drive Chain Lubrication Condition Inspection
If a special lubricant is not available, a heavy oil such as
SAE 90 is preferred to a lighter oil because it will stay on
the chain longer and provide better lubrication.
If the chain appears especially dirty, clean it before lubrication.
NOTICE
The O-rings between the side plates seal ...
Stator Coil Installation
Apply a non-permanent locking agent to the threads of
the stator coil bolts and tighten them.
Torque - Stator Coil Bolts: 12 N·m (1.2 kgf·m, 106 in·lb)
Using a high flash-point solvent, clean off any oil or dirt
that may be on the silicone sealant coating area. Dry
them with a clea ...
Engine Oil
In order for the engine, transmission,
and clutch to function properly, maintain
the engine oil at the proper level,
and change the oil and replace the oil
filter in accordance with the Periodic
Maintenance Chart. Not only do dirt
and metal particles collect in the oil, but
the oil itself los ...