If the charging voltage is good, perform the Pre-Diagnosis Inspection 1 and 2 (see Inquiries to Rider in the Brakes chapter).
If this service code appears even if all checks are ended, replace the KIBS hydraulic unit.
If the service code does not appear, the KIBS system normal (temporary failure).
Intake Air Pressure Sensor #2 Input Voltage Inspection
NOTE
Be sure the battery is fully charged.
Turn the ignition switch to OFF.
Remove the air cleaner housing (see Air Cleaner Housing
Removal in the Fuel System (DFI) chapter).
Disconnect the intake air pressure sensor #2 connector
and connect the measuring adapter [A] between these
con ...
Rear Fender Front Installation
Installation is the reverse of removal. Note the following.
Run the harness, cables and leads correctly (see Cable,
Wire, and Hose Routing section in the Appendix chapter).
When installing the clamp [A] on the rear fender front [B],
install it so that the clamp positions at near the ...
Main Throttle Sensor Resistance Inspection
Turn the ignition switch to OFF.
Measure the main throttle sensor resistance in the same
way as input voltage inspection, note the following.
Disconnect the throttle sensor setting adapter [A] from the
connector of the main harness side.
Special Tool - Throttle Sensor Setting Adapter: 57 ...