AL: Tighten the two clamp bolts alternately two times to ensure even tightening torque.
G: Apply grease.
R: Replacement Parts
G: Apply grease.
L: Apply a non-permanent locking agent.
R: Replacement Parts
Specifications
Check 3-4: Turn Signal Indicator Light (LED) Inspection
Connect the leads in the same circuit as Check 3-2.
Connect the terminal [5] to the battery (+) terminal.
Connect the terminal [6] to the battery (+) terminal.
Check that the turn signal indicator light (LED) [A] goes
on.
If the indicator light does not go on, replace the meter ...
Oil and/or Oil Filter Change
To change the engine oil and replace
oil filter, the engine oil drain bolt and
oil filter must be removed. The oil
change and oil filter replacement
should be done by an authorized
Kawasaki dealer.
A. Engine Oil Drain Bolt
A. Oil Filter
WARNINGEngine oil is a toxic s ...
Amplifier Input Voltage Inspection
NOTE
Be sure the battery is fully charged.
Turn the ignition switch to OFF.
Remove the upper fairing (see Upper Fairing Removal in
the Frame chapter).
Do not disconnect the connectors.
Connect a digital meter to the amplifier connector [A] with
needle adapter set.
Special To ...