The Fluid Pressure Sensors are built in the KIBS Hydraulic Unit. Therefore the voltage cannot be checked directly.
If this service code appears even if all checks are ended, replace the KIBS hydraulic unit
If the service code does not appear, the KIBS system normal (temporary failure).
Transmission Assy Assembly
Install the ball bearing [A] until it is bottomed.
Turn the oil seal side to the bottom.
Special Tool - Bearing Driver Set: 57001-1129
Install the bearing holder [B].
Turn the flat side to the bottom.
Apply a non-permanent locking agent to the bearing
holder bolts [C].
Tighten: ...
City Light (LED) Removal/Installation
Remove:
Upper Fairing Assembly (see Upper Faring Assembly
Removal in the Frame chapter)
Headlight (see Headlight Removal)
Remove the screws [A], and take the city light [B] off the
upper fairing assembly.
Installation is the reverse of removal. Note the following.
When inst ...
Master Cylinder Inspection (Visual Inspection)
Remove the master cylinders (see Front/Rear Master
Cylinder Removal).
Disassemble the front and rear master cylinders (see
Master Cylinder Rubber Parts Replacement in the Periodic
Maintenance chapter).
Check that there are no scratches, rust or pitting on the
inner wall [A] of each ma ...