Kawasaki Ninja Service Manual: Front Master Cylinder Removal

Kawasaki Ninja Service Manual / Brakes / Master Cylinder / Front Master Cylinder Removal

Front Master Cylinder Removal


Front Master Cylinder Removal


NOTICE

Immediately wash away any brake fluid that spills.

Front Master Cylinder Removal


Master Cylinder
...

Front Master Cylinder Installation
Apply silicone grease to the sliding surface of the brake lever pivot bolt. Tighten: Torque - Brake Lever Pivot Bolt: 1.2 N·m (0.12 kgf·m, 11 in·lb) Brake Lever Pivot Bolt Nut: 5.9 N· ...

Other materials:

Camshaft Removal
Remove: Cylinder Head Cover (see Cylinder Head Cover Removal) Crankshaft Sensor Cover (see Crankshaft Sensor Removal in the Electrical System chapter) Using a wrench on the timing rotor bolt [A], turn the crankshaft clockwise until the line [B] (TDC mark for #1,4 pistons) on the timin ...

DFI System
1. ECU 2. Battery 3. Vehicle-down Sensor 4. Exhaust Butterfly Valve Actuator 5. Vacuum Chamber (Other than US, CA and CAL Models) 6. Air Intake Valve Actuator (Other than US, CA and CAL Models) 7. Air Intake Valve (Other than US, CA and CAL Models) 8. Air Flow 9. Air Intake Solenoid Valve ...

Exhaust Butterfly Valve Actuator Sensor Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the front seat (see Front Seat Removal in the Frame chapter). Remove the screws [A] and the exhaust butterfly valve actuator temporarily with the cables installed. Disconnect the exhaust butterf ...