Kawasaki Ninja Service Manual: Gear Position Switch Installation

Kawasaki Ninja Service Manual / Electrical System / Switches and Sensors / Gear Position Switch Installation

Gear Position Switch Installation


Gear Position Switch Removal
Remove: Oil Pump (see Oil pump Removal in the Engine Lubrication System chapter) Engine Sprocket (see Engine Sprocket Removal in the Final Drive chapter) Fuel Tank (see Fuel Tank Removal ...

Gear Position Switch Inspection
NOTE Be sure the transmission and external shift mechanism are good condition. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the connector [A]. ...

Other materials:

Fuel Tank Installation
Note the above WARNING (see Fuel Tank Removal). Run the hoses correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter). Check that the dampers [A] are in place on the fuel tank. If the dampers are damaged or deteriorated, replace them. If the fuel tank brack ...

Special Tools
Bearing Puller: 57001-135 Head Pipe Outer Race Press Shaft: 57001-1075 Steering Stem Nut Wrench: 57001-1100 Bearing Driver Set: 57001-1129 Steering Stem Bearing Driver, 42.5: 57001-1344 Steering Stem Bearing Driver Adapter, 41.5: 57001-1345 Head Pipe Outer Race Driver, 55: 57001- ...

Coolant Filling
Remove the bolts and quick rivets. Detach the tabs and remove the right fairing and cover. A. Bolts B. Quick Rivet C. Large Quick Rivet D. Tabs E. Right Fairing and Cover NOTE The right fairing and cover uses the quick rivets and large quick rivet. The large quick rivet ca ...