Brake Wear Inspection
Inspect the brakes for wear. For each front and rear disc brake caliper, if the thickness of either pad is less than 1 mm (0.04 in.), replace both pads in the caliper as a set. Pad replacement should be done by an authorized Kawasaki dealer.
A. Lining Thickness
B. 1 mm (0.04 in.)
Coolant Level Inspection
Situate the motorcycle so that it is
perpendicular to the ground.
Check the coolant level through the
coolant level gauge on the reserve
tank located to the left of the engine.
The coolant level should be between
the “F” (Full) and “L” (Low) level lines.
A. Reserve Ta ...
Sidestand Installation
Replace the sidestand nut [A] with a new one.
Apply grease to the sliding areas [B].
Tighten the sidestand bolt [C] first, and then the sidestand
nut.
Torque - Sidestand Bolt: 44 N·m (4.5 kgf·m, 32 ft·lb)
Sidestand Nut: 29 N·m (3.0 kgf·m, 21 ft·lb)
Install the spring [D] as sh ...
Inquiries to Rider
Each rider reacts to problems in different ways, so it is important to
confirm what kind of condition
the rider is dissatisfied with.
Try to find out exactly what problem occurs under exactly what
conditions by asking the rider; knowing
this information may help you reproduce the prob ...