The IC igniter is built in the ECU [A].
Interlock Operation Inspection (see Interlock Operation Inspection) Ignition System Troubleshooting (see Ignition System section) ECU Power Supply Inspection (see ECU Power Supply Inspection in the Fuel System (DFI) chapter)
Ignition System Circuit
1. Ignition Switch
2. Engine Stop Switch
3. Stick Coils
4. Spark Plugs
5. Crankshaft Sensor
6. Primary Fuel Injectors
7. Secondary Fuel Injectors
8. Gear Position Switch
9. Sidestand Switch
10. Joint Connector E
11. ECU
12. Battery
13. Main Fuse 30 A
14. ECU Fuse 15 A
15. Frame Grounds
16. Fuel Pump
17. Fuel Pump Relay
18. Relay Box
19. Starter Lockout Switch
20. Ignition Fuse 15 A
21. Fuse Box 1
22. Joint Connector F
23. Vehicle-down Sensor
Intake Air Temperature Sensor Output Voltage Inspection
NOTE
Be sure the battery is fully charged.
Turn the ignition switch to OFF.
Remove the fuel tank (see Fuel Tank Removal in the Fuel
System (DFI) chapter).
Disconnect the intake air temperature sensor connector
and connect the measuring adapter [A] between these
connectors as shown in ...
Engine No. ZXT00JE003022
1. Heat Insulation Rubber Plate
2. For Air Switching Valve Hoses (Place the air switching valve above the
rubber plate.)
3. For Air Suction Valve Cover
4. For Throttle Body Assy Holder #2 and #3
5. For Throttle Body Assy Holder #1
6. For Water Temperature Sensor
7. Insert the tab into th ...
Cable Removal
Remove:
Air Cleaner Housing (see Air Cleaner Housing Removal
in the Fuel System (DFI) chapter)
Right Lower Fairing (see Lower Fairing Removal in the
Frame chapter)
Loosen the nuts [A], and slide the lower end of the clutch
cable to give the cable plenty of play.
Screw in the ...