NOTICE
Never drop the intake air pressure sensor #1 especially on a hard surface. Such a shock to the sensor can damage it.
Disconnect the vacuum hose [A] and remove the rubber damper [B] from the intake air pressure sensor #1 [C].
Valve Clearance Inspection
NOTE
Valve clearance must be checked and adjusted when
the engine is cold (at room temperature).
Remove:
Crankshaft Sensor Cover (see Crankshaft Sensor Removal
in the Electrical System chapter)
Cylinder Head Cover (see Cylinder Head Cover Removal
in the Engine Top End chapter)
Turn t ...
Rocker Arm Installation
Install the both rocker arms [A] so that their marks [B] face
left side.
Replace the tie-rod nut, rear shock absorber nut and
rocker arm nut with new ones.
Apply grease to the inside of the oil seals.
Tighten:
Torque - Rocker Arm Nut: 34 N·m (3.5 kgf·m, 25 ft·lb)
Tie-Rod ...
Cylinder Compression Measurement
NOTE
Use the battery which is fully charged.
Warm up the engine thoroughly.
Stop the engine.
Remove the spark plugs (see Spark Plug Replacement in
the Periodic Maintenance chapter).
Attach the compression gauge [A] and adapter [B] firmly
into the spark plug hole.
Using the startermo ...