Kawasaki Ninja Service Manual: Rocker Arm Installation

Kawasaki Ninja Service Manual / Suspension / Tie-Rod, Rocker Arm / Rocker Arm Installation

Install the both rocker arms [A] so that their marks [B] face left side.

Rocker Arm Installation

Replace the tie-rod nut, rear shock absorber nut and rocker arm nut with new ones.
Apply grease to the inside of the oil seals.
Tighten: Torque - Rocker Arm Nut: 34 N·m (3.5 kgf·m, 25 ft·lb) Tie-Rod Nuts: 34 N·m (3.5 kgf·m, 25 ft·lb) Rear Shock Absorber Nut (Lower): 34 N·m (3.5 kgf·m, 25 ft·lb)
Install the removed parts (see appropriate chapters).

Rocker Arm Removal

Squeeze the brake lever slowly and hold it with a band. Remove the front footpeg bracket bolts. Raise the rear wheel off the ground with the jack (see Rear Shock Absorber Removal). Special ...

Tie-Rod and Rocker Arm Bearing Removal

Remove: Tie-Rod (see Tie-Rod Removal) Rocker Arms (see Rocker Arm Removal) Swingarm (see Swingarm Removal) Sleeves [A] Oil Seals [B] Remove the needle bearings [C], using the bearing re ...

Other materials:

Meter Unit Inspection
Remove the meter unit (see Meter Unit Removal). [1] Battery (+) [2] Fuel Reserve Switch [3] Ground (–) [4] Unused [5] Right Turn Signal Indicator Light (LED) (+) [6] Left Turn Signal Indicator Light (LED) (+) [7] High Beam Indicator Light (LED) (+) [8] Neutral Indicator Light (LED) (� ...

What if I am not Satisfied With My Warranty Service?
If you aren’t satisfied with your dealership’s repair work or operations, it is best to discuss the situation with the appropriate dealership manager. If you have already done this, then contact the dealership’s owner or general manager to request a review of the issue. If you are un ...

Headlight Beam
NOTE Do not turn the bolts because the reflector in the headlight comes off. A. Bolts The left and right adjusters on the headlight can move the direction of the headlight beam to up, down, left and right by turning each adjuster itself as the below table. A. Left Adjuster ...