Kawasaki Ninja Service Manual: Intake Air Pressure Sensor #2 (Service Code 16)

Water Temperature Sensor Resistance Inspection

Refer to the Water Temperature Sensor Inspection in the Electrical System chapter. If the reading is within the standard, but the problem still exists, replace the ECU (see ECU Removal/Instal ...

Intake Air Pressure Sensor #2 Removal

NOTICE Never drop the intake air pressure sensor #2 especially on a hard surface. Such a shock to the sensor can damage it. Remove: Air Cleaner Housing (see Air Cleaner Housing Removal in t ...

Other materials:

KIBS Servicing Precautions
There are a number of important precautions that should be followed servicing the KIBS. This KIBS is designed to be used with a 12 V sealed battery as its power source. Do not use any other battery except for a 12 V sealed battery as a power source. Do not reverse the battery cable connec ...

Starter Clutch Installation
Replace the O-ring [A] with a new one and apply grease. Apply molybdenum disulfide grease to the starter clutch shaft [B]. Install: Starter Clutch [C] Spacer (Small Diameter) [D] Spacer (Large Diameter) [E] Starter Clutch Shaft Starter Clutch Shaft Holder [F] Turn the O-ring si ...

Wheel Rotation Sensor Air Gap Inspection
Raise the front/rear wheel off the ground (see Front/Rear Wheel Removal in the Wheels/Tires chapter). Measure the air gap between the sensor and sensor rotor at several points by turning the wheel slowly. Thickness Gauge [A] Wheel Rotation Sensor Air Gap Standard: Front 0.4 1.6 mm ...