Kawasaki Ninja Service Manual: Intake Air Temperature Sensor Resistance Inspection

Kawasaki Ninja Service Manual / Self-Diagnosis System / Intake Air Temperature Sensor (Service Code 13) / Intake Air Temperature Sensor Resistance Inspection

Intake Air Temperature Sensor Resistance Inspection


NOTE

The sensor and thermometer must not touch the container side or bottom.

Intake Air Temperature Sensor Resistance Standard: 5.4 6.6 kΩ at 0°C
(32°F) 0.29 0.39 kΩ at 80°C (176°F)


Intake Air Temperature Sensor Circuit

Intake Air Temperature Sensor Circuit


1. ECU

2. Intake Air Temperature Sensor

Intake Air Temperature Sensor Output Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the intake air temperat ...

Water Temperature Sensor (Service Code 14)
...

Other materials:

Oxygen Sensor Heater Power Source Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the oxygen sensor lead connector and connect the measuring adapter [A] between these connectors as shown in the fig ...

Catalytic Converter
This motorcycle is equipped with a catalytic converter in the exhaust system. The converter reacts with carbonmonoxide, hydrocarbons and nitrogen oxides to convert them into carbon dioxide, water, nitrogen and oxygen resulting in much cleaner exhaust gases to be discharged into the atmosphe ...

Evaporative Emission Control System Inspection (CAL and SEA-B1 Models)
Inspect the canister as follows. Remove the upper fairing assembly (see Upper Fairing Assembly Removal in the Frame chapter). Remove the canister [A]. Visually inspect the canister for cracks or other damage. If the canister has any cracks or bad damage, replace it with a new one. NO ...