Kawasaki Ninja Service Manual: Oil Pressure Relief Valve

Oil Pan Installation

If the oil filter holder bolt [A] was removed, tighten it. Apply a non-permanent locking agent to the threads of the oil filter holder bolt. Torque - Oil Filter Holder Bolt: 35 N·m (3.6 kgf·m, ...

Oil Pressure Relief Valve Removal

Remove: Oil Pan (see Oil Pan Removal) Oil Pressure Relief Valve [A] ...

Other materials:

ABS Indicator Light (For models equipped with KIBS)
: Normally the ABS indicator light goes on when the ignition switch is turned “ON” and goes off shortly after the motorcycle starts moving. If the ABS is normal, it stays off. If the ABS indicator light shows any of the following, a fault or faults may have taken place in the ABS. You ...

Meter instruments
Upper Button Lower Button Tachometer (with Shift-Up Indicator) Red Zone Ambient Brightness Sensor Turn Signal Indicator Light Warning Indicator Light (Red) Neutral Indicator Light Multifunction Meter High Beam Indicator Light Warning Indicator Light (Yellow) Fuel ...

System Components
1. FI ECU The FI ECU analyzes the motorcycle conditions based on the signals from the front/rear wheel rotation sensors and FI sensors (such as the crankshaft sensor and main throttle sensor), and controls engine power by reducing the number of ignition and retarding the ignition timing. The m ...