Kawasaki Ninja Service Manual: Oil Pressure Relief Valve Installation

Kawasaki Ninja Service Manual / Engine Lubrication System / Oil Pressure Relief Valve / Oil Pressure Relief Valve Installation

NOTICE

Do not apply too much non-permanent locking agent to the threads. This may block the oil passage.

Torque - Oil Pressure Relief Valve: 15 N·m (1.5 kgf·m, 11 ft·lb)

Oil Pressure Relief Valve Removal
Remove: Oil Pan (see Oil Pan Removal) Oil Pressure Relief Valve [A] ...

Oil Pressure Relief Valve Inspection
Remove the oil pressure relief valve (see Oil Pressure Relief Valve Removal). Check to see if the valve [A] slides smoothly when pushing it in with a wooden or other soft rod, and see if it c ...

Other materials:

Shift Pedal Installation
Install the rubber damper to the shift pedal. Turn the chamfered side to inside. Assemble: Shift Lever [A] and Locknut [B] (Left-hand Thread) Shift Pedal [C] and Locknut [D] Tie-Rod [E] Turn the grooved end [F] of the tie-rod to the shift lever. Apply grease to the sliding ...

Stick Coil Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the ECU (see ECU Removal in the Fuel System (DFI) chapter). Do not disconnect the ECU connectors. Connect a digital meter [A] to the connector [B] with the needle adapter set. Special Tool - N ...

Stator Coil Installation
Apply a non-permanent locking agent to the threads of the stator coil bolts and tighten them. Torque - Stator Coil Bolts: 12 N·m (1.2 kgf·m, 106 in·lb) Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clea ...