Oxygen Sensor Heater Resistance Connections: W lead [C] ←→ W lead [D] Standard: 6.7 10.5 Ω at 20° (68°F)
If the reading is out of the standard, replace the sensor.
If the reading is within the standard, check the power source voltage (see Oxygen Sensor Heater Power Source Voltage Inspection).
DFI Power Source
ECU Fuse Removal
Refer to the 30 A Main/15 A ECU Fuse Removal in the
Electrical System chapter.
ECU Fuse Installation
If a fuse fails during operation, inspect the DFI system to
determine the cause, and then replace it with a new fuse
of proper amperage.
Refer to the Fuse Installation in ...
Rear Sprocket Removal
Remove the rear wheel (see Rear Wheel Removal in the
Wheels/Tires chapter).
NOTICE
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks under the wheel so that the disc does
not touch the ground.
Remove:
Rear Sprocket Nu ...
High Speed Compression Damping Adjustment
Turn the high speed compression
damping force adjuster clockwise to
increase damping force or counterclockwise
to decrease it.
NOTICE
Do not turn the compression
damping force adjuster beyond
the fully seated position or the
adjusting mechanism may be
damaged.
A. Compression Da ...