Kawasaki Ninja Service Manual: Piston Ring, Piston Ring Groove Wear Inspection

Kawasaki Ninja Service Manual / Crankshaft/Transmission / Pistons / Piston Ring, Piston Ring Groove Wear Inspection

Check for uneven groove wear by inspecting the ring seating.

The rings should fit perfectly parallel to groove surfaces.

If not, replace the piston and all the piston rings.

With the piston rings in their grooves, make several measurements with a thickness gauge [A] to determine piston ring/groove clearance.

Piston Ring, Piston Ring Groove Wear Inspection

Piston Ring/Groove Clearance Standard:

Top 0.03 0.07 mm (0.0012
0.0028 in.)

Second 0.03 0.06 mm (0.0012
0.0024 in.)

Service Limit:

Top 0.17 mm (0.0067 in.)

Second 0.16 mm (0.0063 in.)

Piston Wear Inspection

Measure the outside diameter [A] of each piston 5 mm (0.20 in.) [B] up from the bottom of the piston at a right angle to the direction of the piston pin. If the measurement is under service ...

Piston Ring Groove Width Inspection

Measure the piston ring groove width. Use a vernier caliper at several points around the piston. Piston Ring Groove Width Standard: Top [A] 0.82 0.84 mm (0.0323 0.0331 in.) Second [B] 0.8 ...

Other materials:

Tachometer
The tachometer shows the engine speed in revolutions per minute (r/min, rpm). On the right side of the tachometer face is a portion called the “red zone”. Engine r/min (rpm) in the red zone is above maximum recommended engine speed and is also above the range for good performance. ...

Thermostat Installation
Replace the O-rings [A] with new ones, and apply grease to them. Assemble: O-rings Thermostat Housing [B] Thermostat [C] Thermostat Cap [D] Install the thermostat [A] in the housing so that the air bleeder hole [B] is on top. Tighten: Torque - Thermostat Cap Bolts: 5.9 N ...

Tail/Brake Light (LED) Removal/Installation
Remove: Upper Seat Cover (see Seat Cover Removal in the Frame chapter) Disconnect the tail/brake light connector [A]. Remove: Tail/Brake Light Mounting Screws [A] Bolts [B] and Brackets [C] Bolt [D] Remove the tail/brake light [A]. Bring down the rear fender rea ...