Kawasaki Ninja Service Manual: Pistons

Crankshaft Main Bearing Insert/Journal Wear Inspection

Split the crankcase (see Crankcase Splitting). Cut strips of plastigage to journal width. Place a strip on each journal parallel to the crankshaft installed in the correct position. Tighten ...

Piston Removal

Remove: Crankshaft (see Crankshaft Removal) Remove the piston together with the connecting rod to the cylinder head side. NOTICE Discard the connecting rod bolts and nuts. To prevent dam ...

Other materials:

Clutch Installation
Apply engine oil to the needle bearing [A] and the sleeve [B]. Install: Needle Bearing Sleeve Install the clutch housing [A]. Fit the holes [B] and projections [C]. Engage the clutch housing gear and the crankshaft primary gear. Install the spacer [A] and the clutch ...

Specifications
Connecting Rod Big End Bearing Insert Selection Crankshaft Main Bearing Insert Selection *: The bearing inserts for Nos. 2 and 4 journals have an oil groove, respectively. ...

Charging Voltage Inspection
Check the battery condition (see Charging Condition Inspection). Warm up the engine to obtain actual alternator operating conditions. Remove the front seat (see Front Seat Removal in the Frame chapter). Check that the ignition switch is turned off, and connect the hand tester [A] to t ...