Kawasaki Ninja Service Manual: Premuffler Chamber Removal

Kawasaki Ninja Service Manual / Engine Top End / Muffler / Premuffler Chamber Removal

Remove: Muffler Body (see Muffler Body Removal) Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Front Seat (see Front Seat Removal in the Frame chapter) Oxygen Sensor (Equipped Models) (see Oxygen Sensor Removal (Equipped Models) in the Electrical System chapter)
Remove the lower ends of the exhaust butterfly valve cables from the pulley of the premuffler chamber (see Exhaust Butterfly Valve Cable Removal).
Loosen the exhaust pipe clamp bolt [A].
Remove the bolt [B].
Pull out the premuffler chamber backward from the exhaust pipe.

Premuffler Chamber Removal

Muffler Body Installation

Replace the muffler body gasket [A] with a new one. Install the muffler body gasket to the premuffler chamber [B] until it is bottomed so that the chamfer side faces premuffler chamber. Ins ...

Premuffler Chamber Installation

Replace the premuffler chamber gasket [A] with a new one. Install the premuffler chamber gasket to the premuffler chamber [B] until it is bottomed so that the chamfer side faces exhaust pip ...

Other materials:

External Shift Mechanism Installation
Install the gear positioning lever [A] as shown in the figure. Install: Spring [B] Washer [C] Tighten: Torque - Gear Positioning Lever Bolt [D]: 12 N·m (1.2 kgf·m, 106 in·lb) Assemble: Ratchet [A] Pawls [B] Pins [C] Springs [D] Install the shift ratchet ...

Throttle Body Assy Assembly
Before assembling, blow away dirt or dust from the throttle body and delivery pipe assy by applying compressed air. Replace the O-rings [A] of the joint pipe [B] with new ones. Apply engine oil to the new O-rings, and insert it to the delivery pipes [C]. Insert the joint pipe so th ...

Front Wheel Rotation Sensor Signal (Service Code 27)
Front Wheel Rotation Sensor Signal Inspection The front wheel rotation sensor sends the signal to the ECU through the KIBS hydraulic unit (KIBS equipped models). For other than KIBS equipped models, the signal is sent directly to the ECU. The ECU uses the wheel rotation sensor signal for KTRC ...