Oxygen Sensor Heater Power Source Voltage Inspection
NOTE
Be sure the battery is fully charged.
Turn the ignition switch to OFF.
Remove the fuel tank (see Fuel Tank Removal in the Fuel
System (DFI) chapter).
Disconnect the oxygen sensor lead connector and connect
the measuring adapter [A] between these connectors
as shown in the fig ...
Crankshaft Side Clearance Inspection
Insert a thickness gauge [A] between the thrust washer
[B] on the crankcase and the crank web [C] at the #3 main
journal to determine clearance.
If the clearance exceeds the service limit, replace the
thrust washers as a set and check the width of the crankshaft
#3 main journal.
Cra ...
Tie-Rod and Rocker Arm Bearing Removal
Remove:
Tie-Rod (see Tie-Rod Removal)
Rocker Arms (see Rocker Arm Removal)
Swingarm (see Swingarm Removal)
Sleeves [A]
Oil Seals [B]
Remove the needle bearings [C], using the bearing remover
head and bearing remover shaft.
Special Tools - Bearing Remover Head,
15 ×
17: ...