Kawasaki Ninja Service Manual: Fuel Pump Relay (Service Code 46)

Kawasaki Ninja Service Manual / Self-Diagnosis System / Fuel Pump Relay (Service Code 46)

ECU Communication Error (Service Code 39)
ECU Communication Line Inspection When the data is not sent from the ECU to the meter unit for more than about 10 seconds, the service code 39 is displayed. The data is sent through the CAN commun ...

Fuel Pump Relay Removal/Installation
The fuel pump relay is built in the relay box [A]. Refer to the Relay Box Removal in the Electrical System chapter. ...

Other materials:

Vehicle-down Sensor Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Disconnect the vehicle-down sensor connector and connect the measuring adapter [A] between these connectors as shown in the figure. Main Harness [B] Vehicle-down Sensor [C] Special Tool - Measuring Adapte ...

Front Wheel Installation
NOTE The direction of the wheel rotation [A] is shown by an arrow [B] on the wheel spoke. Check the wheel rotation mark on the front wheel and install it. Apply high-temperature grease to the grease seal lips. Fit the collars [A] on the both sides of the hub. The collars are i ...

Spring Preload Adjustment
To adjust the spring preload, turn the spring preload adjuster [A]. The standard adjuster setting is the 6 turns in from the fully counterclockwise position. WARNINGIf both adjusters are not adjusted equally, handling may be impaired and a hazardous condition may result. B ...