High or low beam can be selected
with the dimmer switch. When the
headlight is on high beam ( 
), the
high beam indicator light goes on.
High beam.......(
)
Low beam.......( 
)
NOTE
When the headlight is on high beam, both headlights go on. When the headlight is on low beam, only one headlight goes on.
Dimmer Switch
Turn Signal SwitchParts Location
NOTE
The front and rear wheel rotation sensors and rotors are
standard parts of this motorcycle.
Front Wheel Rotation Sensor [A]
Front Wheel Rotation Sensor Rotor [B]
Rear Wheel Rotation Sensor [C]
Rear Wheel Rotation Sensor Rotor [D]
ABS Indicator Light (LED) [E]
KIBS Indicator Ligh ...
Air Intake Duct Disassembly
(Other than US, CA and CAL Models)
Remove:
Air Intake Duct (see Air Intake Duct Removal)
Seal [A] and Screen [B]
Turn the air intake valve actuator [C] counterclockwise
(90°).
Remove the shaft [A] of the air intake valve actuator.
Remove:
Pad [A]
Screws [B]
Air Intake Valve [C]
...
Idle Speed Control Valve Actuator Installation
Replace the O-ring [A] with a new one.
Apply engine oil to the new O-ring.
Install the idle speed control valve [A] as shown in the
figure.
10° [B]
Tighten:
Torque - Idle Speed Control Valve Actuator Retainer
Screws: 2.06 N·m (0.21 kgf·m, 18 in·lb)
Install th ...