Kawasaki Ninja Service Manual: Handlebar

Steering Stem Warp Inspection

Whenever the steering stem is removed, or if the steering can not be adjusted for smooth action, check the steering stem for straightness. If the steering stem [A] is bent, replace the steer ...

Handlebar Removal

Remove: Steering Damper (see Steering Damper Removal) Clutch Lever Clamp Bolts [A] Clutch Lever Assembly [B] Left Switch Housing [C] Handlebar Weight [D] Left Handlebar Grip [E] ...

Other materials:

KIBS Hydraulic Unit Removal
NOTICE The KIBS hydraulic unit [A] has been adjusted and set with precision at the factory. Therefore, it should be handled carefully, never struck sharply, as with a hammer, or allowed to fall on a hard surface. Be careful not to get water or mud on the KIBS hydraulic unit. Drain the b ...

ESD (Electronic Steering Damper) ECU Removal (ZX1000JD/KD)
NOTICE Never drop the ECU especially on a hard surface. Such a shock to the ECU can damage it. Lift up the front portion of the fuel tank, and hold it with a suitable bar or block (see Fuel Tank Removal in the Fuel System (DFI) chapter). NOTE When removing the ESD ECU only, there ...

Sidestand Switch Operation Inspection
Raise the rear wheel off the ground with the stand (see Rear Wheel Removal in the Wheels/Tires chapter). Inspect the sidestand switch [A] operation accordance to below table. Sidestand Switch Operation If the sidestand switch operation does not work, inspect or replace the foll ...