Kawasaki Ninja Service Manual: Steering

Kawasaki Ninja Service Manual / Steering

Rocker Arm/Tie-Rod Bearing, Sleeve Inspection
NOTICE Do not remove the bearings for inspection. Removal may damage them. Visually inspect the rocker arm, or tie-rod sleeves [A] and needle bearings [B]. The rollers in a needle bearin ...

Exploded View
11. ZX1000JD/KD AD: Apply adhesive. AL: Tighten the two clamp bolts alternately two times to ensure even tightening torque. G: Apply grease. L: Apply a non-permanent locking agent. ...

Other materials:

Bolts, Nuts and Fasteners Tightness Inspection
Check the tightness of the bolts and nuts listed here. Also, check to see that each cotter pin is in place and in good condition. NOTE For the engine fasteners, check the tightness of them when the engine is cold (at room temperature). If there are loose fasteners, retighten them to ...

Special Tools
Inside Circlip Pliers: 57001-143 Oil Seal & Bearing Remover: 57001-1058 Bearing Driver Set: 57001-1129 Jack: 57001-1238 Bearing Remover Head, 15 × 17: 57001-1267 Fork Oil Level Gauge: 57001-1290 Bearing Remover Shaft, 13: 57001-1377 Fork Oil Seal Driver, 43: 57001-15 ...

Tachometer
The tachometer shows the engine speed in revolutions per minute (r/min, rpm). On the right side of the tachometer face is a portion called the “red zone�. Engine r/min (rpm) in the red zone is above maximum recommended engine speed and is also above the range for good performance. ...