General Specifications
OverviewSolenoid Valve Inspection (Service Code b 13, b 14, b 17, b 18)
The solenoid valve is built in the KIBS Hydraulic Unit [A].
Therefore the solenoid valve cannot be checked directly.
Perform the Pre-Diagnosis Inspection 1 and 2 (see Inquiries
to Rider in the Brakes chapter).
If any of these service codes appears even if all checks
are ended, replace t ...
Battery Removal
Remove the rider’s seat (see Seats
section in the GENERAL INFORMATION
chapter).
Turn the ignition switch to “OFF” and
disconnect the (–) cable from the battery.
Remove the red cap form the (+) terminal,
and disconnect the (+) cables
from the battery.
NOTE
The battery is ...
Coolant Level Inspection
Situate the motorcycle so that it is
perpendicular to the ground.
Check the coolant level through the
coolant level gauge on the reserve
tank located to the left of the engine.
The coolant level should be between
the “F” (Full) and “L” (Low) level lines.
A. Reserve Ta ...