The brake lever adjuster has 6 positions so that the brake lever position can be adjusted to suit the operator’s hand.
The distance from the grip to the lever is minimum at number 6 and maximum at number 1.
Thermostat Inspection
Remove the thermostat (see Thermostat Removal).
Inspect the thermostat valve [A] at room temperature.
If the valve is open, replace the thermostat with a new
one.
To check valve opening temperature, suspend the thermostat
[A] in a container of water and raise the temperature
of ...
Check 3-1: CAN Communication Line Resistance Inspection
Set the hand tester [A] to the ×1 Ω range and connect it
to the terminal [11] and [12] in the meter unit.
Special Tool - Hand Tester: 57001-1394
CAN Communication Line Resistance (at Meter Unit)
Standard: 122 126 Ω
If the tester reading is not specified, replace the meter ...
Front Brake Pad Installation
Check that the pad spring [A] is in place on the caliper.
Push the caliper pistons in by hand as far as they will go.
Install the brake pads [A] on the pad spring correctly.
Fit the pad into the groove of the caliper as shown in the
figure.
Install the pad pins while pushing t ...